Introduction

A rotary table is a precision positioning tool used in CNC
machining centers to precisely position the part at the required
angle to perform multiple operations in one setup. A rotary table can be installed as a fourth axis with X, Y and Z machining axes to enable machining such as cam machining, blade machining, spiral groove, etc , and can be a machining center 3-axis rotation It is available on request, only the rotary table can be used with some work tools, tools such as dead center, rotary center axis or background must be used, there are hand tools, power tools, etc away Check the correct size of the turntable

Tips for choosing a size.

a)Check the correct bend of the section.

b)Check the height of the center of the table.

c)Check the distance between balls for a multi-round table.

d)In vertical mode, if the length of the part exceeds 100 mm, it is
recommended to use a tail support.

e)The main part can use the power of the rotary table depending on the load and torque Use the high block to spin up.

Select the grinding table based on the drying torque.

Check the mechanical properties required to
perform the job.

Check the distance from the center and do the work Calculation of the torque used during mechanical operation (torque = force x distance).

The torque of the unit must be equal to the torque capacity of the table clamp.

Check the type of clamp required (hydraulic or pneumatic.

Choose a machine based on unit weight.

Check the weight of parts and accessories The dead weight of the parts and accessories must be within the capacity of the turntable.

By supporting the tail, the vertical load capacity of the turntable is equal to the horizontal load capacity.

Selection of record players based on the accuracy of the signal.

Check that the required part is correct. If accuracy is specified in mm check the required diameter. Converting the precision of the rotary table index specified in seconds of arc to millimeters in diameter during operation correct index can be achieved by using an additional high resolution encoder mounted on the table axis 3 Engine.

Selection based on engine capacity.

Check machining strokes and ensure that the workpiece falls into the machining area when the rotary table is mounted on the machine bed. Also
check the website for gear shifting Even a tool changer should not be confused with a turntable · The total weight of the turntable, including the storage area, must be equal to the load capacity of the equipment. After mounting on the machine bed, in the middle pin gap, check the position of the rotary table guard and the machine guard · If there is sediment,
we can use the rear engine mounting table, if there is a lot of space between the car table and the car windshield, the table is on
the right side.

Selection of the rotary table based on the ability of the operator.

Check whether the machine operator can grip the fourth axis for a single-axis table and the fourth and fifth axes for a two-axis table. If the machine is not able to operate the fourth wheel, we can also consider the independent operator, if the continuous installation of the part and the machine axles is not required to perform the work · In some cases, the controllers can only use 4 axes, and the fifth axis can be used for indexing Matched Sources.